Hi i Reworked my kess 3.099 and it worked but when i flash with jlink my nxp to 4.024 from this below BubbaFet bin i have problem , now when i start ksuite i have error "restart the program to apply the changes", so i think i have bad sdcard files, anybody help me with link to sdcard files 4.024 please PM
firmware 4.024 can work with k-suite 2.32 ?
Last edited by adekbws; 19th September, 2017 at 10:46 AM.
I see people recommending using 10uf 16v tantalum caps, but in the picture (which says it's original board) all the 10uf capacitors are 10 volts (marked as 106A) not 16 volts.
Can anyone confirm if original board use 10v or 16v for the 10uf caps?
Use this TPSB106K020R1000
Last edited by wokcz; 24th September, 2017 at 03:09 PM.
anyone try china good quality 5.017 kess write simos 18.1 4mb binary ?
working ?
read not working not problem i have original file
Only with sw 2.34 work good...
Gentlemen. I stand before buying KESS v2 5.017 china with green PCB or red PCB which is a little more expensive. I'm going to do rework so how do you think the version would be better? Box will just to my private usage
Last edited by pocinas; 8th October, 2017 at 03:12 PM.
Please you sell Ktag without cks error in write and how much for your device ?
Thanks .
i have tried to add tokens with rar file with cfg files with no success. then i try to reset tokens like movie of chinesse cd but now kess is out... soft says to me that i have to restart to aply changes but i restart and this message take me again. if i try to open ksuite 2.08 it runs but all protocols are deactivated. what happen? dead kess? could i repair it? thanks
a link for buy a good tool ?
if someone need good 5.017 eu PM for more details...
Chiptuning - Diesel / Petrol / Stage1,2,3 / HIGH Petrol Tuning
DSG TUNING
DPF / EGR / TVA / SAI / Lambda
Crackle map ( Launch Control + No lift Shift + Antilag )
File Service
PCMFLASH / BFLASH / AMT BST / AMT MPPS / TGFLASH / BITBOX / EDCSUITEPRO - Genuine USER
Bookmarks