Take new eeprom
Hi to everyone
Seems that i have a big problem while trying to make key For F30
FEM don't communicate anymore and weird sound when connect to VVDI2 and 12V on bench before even finish to program the FEM and be able
to read most information in case we wanted to change it
we backup the coding and read the chip 95128 when solder it again In wrong position the problem begin
Now the chip is in right position but same problem
we even change the chip but now way
thank you for any help
Last edited by adjee; 23rd March, 2018 at 10:57 AM.
Take new eeprom
Renault ECU tool / IO terminal / A.S.W
Hi i have problem prepare transporder for Mercedes W168 PCF7931 after press write is unknow transporder. Pcf7931AS id73 read as sokymat 8E thanks for help
This happened after service eeprom write?
Renault ECU tool / IO terminal / A.S.W
yugo45 (23rd March, 2018)
This is what I am asking my self all this time, What is the purpose doing it OBD , if you have to take CAS and read eeprom /flash back up ?
If you do that you can do key with key tag tool.
And not just VVDI , all other tools are same way. So waste money for authorization like this , in other end you can do it with key tag tool.
Pin 5 of eeprom 24c32/64 needs to be connect to ground. Every dash is different.
https://www.youtube.com/watch?v=Fq6M...ature=youtu.be
However I tried this with VVDI and did not work on one dash , I never try after that.
Last edited by yugo45; 23rd March, 2018 at 04:30 PM.
kire106ka (29th March, 2018)
Hi there folks....
Got a cluster of a VW AMAROK. Seems like somebody worked on it and left it in service mode. CLuster comes on but is in service mode. I can read / write eeprom and immo data without a key. When I read eeprom the Address 1430 = FFFFFF (for those who know what service mode address is).
How can I get this cluster out of service mode since I don't have the original file. I tried contacting the person who apparently worked on it and he is not sending em the original dump.
What's the solution of coding a key and getting this vehicle going?
One more thing is that VVDI Identifies it as NEC + 24C32 whereas this cluster is actually 24C64. I opened it and checked it too......
Upload any 24c64 immo block to it and restart it. Than act like all key lost.
May work i think
I have the same problem.how to solve it? error e0-9c
Bookmarks