Thank you,we have revised gokart's va2 problem.Just need to update when the version is ready(it's processing).
gokart (13th October, 2017)
Probe to high.jpgTo comment on you first cut key, your probe seems to be to high.
It needs to touch the tip, not the rounded area of the tip.
This causes the cuts to be of place.
Or try this,
ic card 1125
cuts 174828
Last edited by rob h; 13th October, 2017 at 04:23 PM.
how do i cut this key with my condor.
key code - B1765
intacode - QH72HQ
not sure how to do this....help!
thanks
DJ
Enter into the "key database",select Toyota,input key code B1765,then cut
Hi there
Seems I am having an electrical conduct issue on my machine....
Many times when I tell the machine to start cutting after decode or even after manually entering bittings it will move a little then stop and at the bottom of the screen says..."PROBE DETECTED".
Sometime It starts cutting after 3rd attempt. Sometimes works first attempt.
I also have a problem decoding some HU92 keys. It sometimes just won't decode correctly.
In the past month it has snapped 2 decoder points. One was on the VA2 key but LOUIS21 says it must be dirt on the key.
The other other day I wanted to cut a FO21 (Ford Tibbe) and I clamped in the key and all ready to go. I press start and it goes to measure the key as it usually. It touched the key and the mioved to the clamp and continued all the way breaking the Decoder tip. No Dirt at all. It's shining clean. I then noticed on the key where the decoder touched, a notch, meaning that the decoder pressed very hard onto the key and probably didn't sense the key correctly.
This problem is intermittent. When I run the Electrical conductivity test it seems fine, but bear in mind that when doing test the Motor isn't moving front and back. The problem seems to rise it's head when the motor moves front and back that it looses conductivity / gets false conductivity.
Jobeso66 (4th November, 2017)
Bookmarks