>>>>>>>>>>>>>>CONDOR KEYCUTTERS <<<<<<<<<<<<<

[Maartinj]

most of time calibration have wrong value, post a screen with details

[auto techniek]

Is there any difference if you use 1,5 mm which the machine comes with and 2 mm which I use now.

Do I have to aligh the tip of the key with the first line?

[Maartinj]

Is there any difference if you use 1,5 mm which the machine comes with and 2 mm which I use now.

Do I have to aligh the tip of the key with the first line?

machine comes with 1,5 and 2,5mm
but you need calibrate clamp, probe, cutter and then select proper profile

[sleepyrz]

Is there any difference if you use 1,5 mm which the machine comes with and 2 mm which I use now.

Do I have to aligh the tip of the key with the first line?

did you cut it with the same 2mm for all of the keys?

or did you change cutters?

[szengen]

I am asking for the configuration of the sn machine: KM02254310, in Polish, I understand in English, but my employees do not, I would not like to spoil the machine, with much respect. Lockmaster Multiserwis

[auto techniek]

Did use 1,5 and 2 mm cutters

Which option do I need to use? Duplicate key or cut by bitting? What is the difference if I need to decode and cut a key.

machine comes with 1,5 and 2,5mm
but you need calibrate clamp, probe, cutter and then select proper profile

[sleepyrz]

how can i cut dimple keys?


the custom key tool has dimple keys in there

what drill would i use?

[madaxe]

how can i cut dimple keys?

the custom key tool has dimple keys in there

what drill would i use?

I noticed the advertising says dimple keys, but could find no cutting bits, software entries or anything that showed it actually works with dimple keys. Its a shame, if the dimple cutting option were useable it would be a very economical tool.

I'd settle for a better custom Key tool. One where individual cards could be saved and shared then people might make them for xhorse.

[sleepyrz]

well i guess ill have to play with it and see what i can figure out...........



got my single sided m4 jaw yesterday as well



lots of playing around to do

[sleepyrz]

nope cant even make a custom profile for a dimple key............

crippled software

key thickness error everytime when trying to set key parameters

[amigokola]

With new additional clamps for XC-002 are we able to cut old HU49 VW key for example ??
Cant do it with standard clamps now...
.................................................. .................................................. ................................
Ok Samic wrote to me that XC-002 doesnt support this profile.

[sdnatlst]

is there any solutions yet for renault emergency key card keys? i have a customer wanting this tomorrow and didnt realise i couldnt do it until i read this thread that people had problems?

[Brat]

is there any solutions yet for renault emergency key card keys? i have a customer wanting this tomorrow and didnt realise i couldnt do it until i read this thread that people had problems?

cut part from credit cart and insert under blade,work perfect.

[sdnatlst]

thanks, then just select car normally, tomorrow i have 2008 Renault Espace for example?


Does it decode OK this way too, credit card bit underneath?

[Brat]

yes.

The message you have entered is too short. Please lengthen your message to at least 10 characters.