Date of publication 19.09.2016 -UHDS ALLInOne 3.1.2.1 -Added new version BSI Continental Write KM -Added new version W204/W212 Dash Write Km
Date of publication 19.09.2016 -UHDS ALLInOne 3.1.2.1 -Added new version BSI Continental Write KM -Added new version W204/W212 Dash Write Km
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
I have problem PSA UHDS clear history by obd i get 'Erase history command refused'. Car is C5 2012 DCM3.5. If I click erase history again I have 'erase history Ok' but I still see it in diagbox. -- all ok just need to press erase history few times
C5 dash by obd ok.
Faraday (23rd September, 2016)
This is normal you mast try 3 or 4 or more times till you see the soft deleting +- 2, 3 secunds. It will delete 100%
Faraday (25th September, 2016)
Screen Shot 2016-09-25 at 10.48.27 AM.jpgHi,
Working on a Temic Immo Box from SPrinter 2004 and it contains 4J47Y. Smok diagram shows if you have SN > 3800, you use the purple wire and also I notice it states to use the green if MCU is secure, I assume it's secure so please advise if the green wire goes on the same point of the 5V red or you use one of the 2?
Thanks!
gttuning (5th October, 2016)
Maybe if green is used then red goes on other red position
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
duplikeytor (25th September, 2016)
In picture shows 2 x red maybe when green is used only red on left is used
Oh and by the way if my post has been at all helpfull
please press the little THANKS tab
You have to connect, like it is on picture; 2x red wire and the green wire together with the red one on the same soldering point.
duplikeytor (26th September, 2016), teerak2uk (25th September, 2016)
Today i try/ test edc17cp14 with smok. Read all immo data from ori and doner on the bench then try to adapt thru obd the way how is manual says, but this is the 3 rd edc17 which fails to do it.
Sent from my SM-G925F using Tapatalk
Bookmarks