Mate..could you go do an introduction to everyone please ? Introduce Yourself
Thank you....and welcome to Kaos...
Kinda new to this been doing it off and on for last year have a USA prog and a 2003 Tahoe failed to write thru OBD, need to program where is eeprom located? Do needles need to be removed? If so is there a soldering option to not have to dismantle cluster? Nice to meet everyone BTW if any of you guys are in the DFW pm me could always use help and swap experience.
Mate..could you go do an introduction to everyone please ? Introduce Yourself
Thank you....and welcome to Kaos...
Aaahh ! I love the smell of Eeprom in the morning...
" We'll come in low out of the rising sun, and about a mile out, we'll put on the music . . . "
Have a read of this thread....
http://www.digital-kaos.co.uk/forums...ight=silverado
Please DO NOT PM me asking for help.
Post in the forum, that is what it is here for.
jomberykaso (11th September, 2016)
Open it up easy to take needles out and look for eeprom..
SAME CHASIS SAME DASH SAME EPROM, AND WORKS BY OBD , TRY FIRMWARE UPDATE AND TRY AGAIN DOORS CLOSED , NOT HOLD TRIP BUTTON DOWN. OR TRY A FEW TIMES TILL IT HITS
Reading is fundamental, asking is easy............................
MileageAudit5 (16th July, 2020)
Same as any full size GM truck from 2003-2006. Silverado, Sierra, Suburban, Tahoe, Yukon, Avalanche, Escalade, H2.
Please DO NOT PM me asking for help.
Post in the forum, that is what it is here for.
Bookmarks