I need help on these
Ducati 696 with digitec dash epp 24c16
Original dashboard was lost in accident someone stole it so i found another one read epp and make a t5 transponder byt i suppose i didnt make it good.Question is dash must be sinchronised with ecu or not ecu is siemens vdo.
After i program transponder read again i found it on line 130 data bytes in epp
Here is dump from dash
Thanks
IF YOU THINK IT'S EXPENCIVE TO HIRE A PROFESSIONAL,WAIT UNTIL YOU HIRE AN AMATEUR
bearheroes (2nd October, 2016), kire106ka (2nd October, 2016)
I dont understand what to clone i do not have original dash so even with pin code i didnt make it it stuck in programing mode
For programing on byke must i have preprogramed transponders or how to do it sinchronisation with ecu if needed because i'am not familiar with ducati never make it
these is transponder info after programing
be fa 00 09 04 42 48 01 tango
5f0090b042128070 zed
0d424801befa0009 tag
If it was a coustomer bike i would not take it is my friends bike so i must make it no excuses possible
IF YOU THINK IT'S EXPENCIVE TO HIRE A PROFESSIONAL,WAIT UNTIL YOU HIRE AN AMATEUR
hi
pin code 86431
Write transponder T5 on the key
0000000000 F1 C2 F8 zedBULL format (Look to see)
ON BOARD PROGRAM
With the master key it is possible to programme/delete keys.
The procedure is as follows:
You must memorise at least 2 keys with different codes to successfully
obtain a correct programming procedure .
1) Insert the master key and turn to the `on' position.
2) When the "CODE" warning light has gone out, remove the key.
3) Insert the key to be programmed and turn to the `on' position.
Correct programming will be confirmed by the "CODE" warning
light going out.
4) Remove the key.
5) Repeat 3) and 4) with all the keys to be programmed.
6) Insert the master key and turn to the `on' position.
7) When the "CODE" warning light has gone out, remove the key.
Anomalies are made apparent by the "CODE" warning light failing to
go out. In such cases repeat the programming procedure from the
beginning.
N.B. It is necessary to programme all the keys available as keys
programmed with the procedure previous to the one described
will be deleted.
Last edited by ali re; 16th November, 2016 at 07:16 PM.
Best Regards
locksmith
No personal details
Bookmarks