TERMINATOR1000 (27th May, 2017)
Well @Samic already say, To take a few days off, after ELF.
Xhorse how good he is. Is that they update and correct mistakes in the early future. That's why my machines are also Xhorse.
----------
The Handy-Baby transponder does not serve to clone (4D and 46)
The transponder of CN2 if it serves for 4D
The CN3 Transponder is not good for ID46 calls for a model (XH-46)
*What does this mean? We can only use XHorse tranponder? -> (XH-??)
Last edited by lidons; 27th May, 2017 at 06:07 PM.
excuse my English, is the best.
TERMINATOR1000 (27th May, 2017)
In the part of ID transponder in edit,
It gives us a lot of play with the ID48s.
I can write all the pages, including the Identification and the pin.
Valid for id48 of HandyBaby
excuse my English, is the best.
electromech (2nd June, 2017)
Menu -> Remote Prepare
It does not work .. and leaves the HX command dead. After loading configuration, does not emit Frequency and does not turn on LED. (Dead)
---
excuse my English, is the best.
electromech (2nd June, 2017)
Has anybody started to receive there's in the uk now!!
It has been said that they are sending them out in batches if 20 as they receive them!
From what I know English still not ready. So they probably are not sending anything yet.
I guess they have to do an update to the software. Because this version I think is BETA-SW test.
Last edited by lidons; 10th June, 2017 at 12:30 PM.
excuse my English, is the best.
I also was told English will not be available with online update but only by sending the device back at Xhorse, instead.
Though it's hard for me to believe this....
Next week big order arrive to EU.
find some vvdi key tool youtube video:
https://www.youtube.com/channel/UCzy...=vvdi+key+tool
hope it help
Last edited by xhorsesusie; 13th June, 2017 at 10:36 AM.
Brought mine a few weeks ago!
on the promise that they would give me a date!
Still nothing?
Please samic just a rough time on when it comes
so I can buy a cn900 or something cheap to do id46 onto a carbon chip!!
Received mine today. Ordered from a vendor in the states, came with v1.2.8
Haven't had much of a chance to play with it but browsed through menus etc.
Would be interested to see if they can get the id48 cloning enabled
Last edited by dmp; 22nd June, 2017 at 01:05 AM.
Bookmarks