Need to unlock a Steering angle sensor Panasonic 89245-30110 it has 24cs02a it has internal error and is stuck in -834deg, tryed dump from good sensor and now it reads until 45deg and gets error, think need to virginize dump in order to self align magnets inside, I tryed a lot of positions of magnets but hard to set to 0 deg, has anyone method to virgin dump and recover sensor, thanks.
LooserX (9th May, 2017)
Hello friend, this is orig dump with error...
br.balazs (25th February, 2017)
here you go
try and report please
DTC should goes off
after Test mode run for 1 minuets
br.balazs (25th February, 2017), Dotcom2509 (5th December, 2018), Javed11 (12th June, 2017), LooserX (9th May, 2017), luis12 (1st November, 2016), pcofre (1st October, 2019), ZIOMAL4340 (4th October, 2017)
No luck friend, error appears in 20degrees or more, I test with a good sensor dump and same issue, tryed good board on bad sensor body (magnets assembly) Works OK, so magnets dont are problema, think that need a virgin dump to try recover it or perhaps micro has part of culprit, any one has solved this ?? I see Iprog has solution. Thanks any help.
????
After write my files what happen??
Write my files turn on ignition then check what dtc have
Clear dtc and check all dtc gone if yes
Go to Abs system and utility Test mode run. Also check how about degree have
It should be 0 when steering wheel ahead
Sent from my C5502 using Tapatalk
cougar89 (23rd April, 2018), LooserX (9th May, 2017), luis12 (2nd November, 2016), rtbdiagnostic (12th January, 2020), vanos batam (2nd February, 2022)
Ok the blockage gones, now I center sensor and conect then read is about 0 degrees so when moves to any direction counter or clockwise at about 10 deg it takes error telling internal error and again turn on warn light, tryed with good sensor and put good file to bad sensor and same result, question you can interchange a good dump from good sensor to any bad sensor ? or it has any sincro. Thanks for your help friend.
SOLVED... thanks to BRAYN for made a reset wich used to find the problem and make scrypt for solution of futures modules.
rtbdiagnostic (12th January, 2020)
Javed11 (10th May, 2017)
Everyone who is doing this again: 1. don't move the magnets never. 2. Use only the native dump
I have the solution for 89245-74010, 89245-74020, 89245-30110
Friend this problem sets when you detach Sir coil and turn Wheel more than 2 1/2 turn to any direction, maxium permit is 2 turns from center, if exeeds the known +854 or -854 sets. Only way to recover is cleaning error from eprom
rtbdiagnostic (14th August, 2019)
pls share me l the dump for steering angel. 89245-30110 pls help ,, can send my email.. *Removed Email Adress...
Last edited by Johnner; 10th October, 2017 at 11:17 PM.
Bookmarks