I would suggest you to take out the eeprom and read with an eeprom reader.
I done lots of them before...
My best regards and happy new year.
Sent from my GT-I8260 using Tapatalk
Hello
happy new year for all menber!!!
i must to change the ecu because it is out of order
how i can read the eeprom in this ecu
i have immotool 2008 but i have some information but i need all information for read the eeprom 95160
i need all pinout for read this eeprom hybrid
thank to all
best regard
I would suggest you to take out the eeprom and read with an eeprom reader.
I done lots of them before...
My best regards and happy new year.
Sent from my GT-I8260 using Tapatalk
hello
soory i have forget to put the picture of the ecu it is modele hybrid!!!
look the eeprom
thank in advance best regard
ktome (22nd September, 2023)
You don?t need to read the eprom. Make immo off !!
But, i looked to my archive. I made IAW5NR.C2. PCB looks the same. I cutted all cables away from the eprom. So, eprom without function. Then, i removed pin in plug from constantly voltage supply (30). Then, i made a bridge between constantly voltage supply (30) and ACC (ignition on, 15) on pcb directly. ECU MAY NOT HAVE VOLTAGE WHILE IGNITION OFF !!!! Works like a charme !
I am not sure about the other partnumber in your case, but pcb looks the same !
Please press THX and REP if it helps !!
Jan
Last edited by Jan1980; 1st January, 2017 at 02:17 PM.
HELLO
thank i find in the wweb this connection
i will report
best regard
HI!
l try to read with upa. But not ok!! I see UID3.2 pinout but not ok!
Upa write me CS error!!!
Can you help to me?
thx
Last edited by kiwi1hu; 3rd April, 2018 at 10:51 AM.
Digiprog V4.94, USProg V04 Full ,
X-prog M Full. Original, BMW ICOM A2 ,
MB SD CONNECT C4, X-Tool V11.46 ,, K-Tag Full orig , Flex Full
çözüm varmı
Bookmarks