This happens very usual...i think it happens because xprog needs to lift pin and we don't...btw i never met it again after i made it ori.
Sent from my iPhone using Tapatalk
Hi, i'm try to clone a sam from a smart 451
sam have 3L80R 9S12B128 mcu, programmed eeprom ok, programmed flash ok, readed again for check eeprom writed ok, flash filled with FF from 0 to 40000, ori flash have data into 0-40000 address. Sometimes don't recognize 9S12 type, and i have to choose manually 9S12HZ128 to read it.
bad xprog hardware?
This happens very usual...i think it happens because xprog needs to lift pin and we don't...btw i never met it again after i made it ori.
Sent from my iPhone using Tapatalk
Professional BMW immo solutions
Macedonia is one and GREEK!!!
Ori sw...
Sent from my iPhone using Tapatalk
Professional BMW immo solutions
Macedonia is one and GREEK!!!
Bookmarks