program ori file in 29f400 with programmer - must open ecu and desolder flash
Hello Guys,i think i have got a big problem.. I tried to upload a new file to my ECU. unfortunatly i used the wrong cardriver (gellato v54 tool-0386) i used the Seat Ibiza EDC15P (1.4/1.9)..
i tried to upload the original file with the right driver, but i get these errors.
http://imgur.com/9uy5UPp
http://imgur.com/Zj4GpMn
map and remap.zip
these are the files i tried to upload. now the car wont start. is it possible to recover my ecu? if yes, what have i to do?
thanks for your help, Eric
Last edited by vicious425; 23rd April, 2017 at 10:21 AM.
program ori file in 29f400 with programmer - must open ecu and desolder flash
I can not understand you read it and failed in writting?no problem with galletto 1260.now only external programmer.
i think i bricked my ECU. now i try to recover it. but i dont know how yet. the reading was finde. then i tried to write it but with the wrong cardriver. now the car wont start anymore. i get "error send wake wag"
easy
program 29fxx with beeprog
bcm2 elv adapt online offline -echange immodata -clone immodata sinchro bcm elv medc17 edc17 Crafter EZS e EDC17 sinchro -DPF/ EGR/ DTC/ removal/: IMMO ADAPT edc16 EDC17 edc17c64 C74 NOW WORKING MED17/MEV17/ VAG ecu clone full working all
PCR2.1 FULL CLONE ou adapt, clone all edc17 me17 , etc / dash echange immodata repair immodata add key etc etc
First try to reprogram it in boot mode, if not helping buy cheap minipro programmer and adapter for flash chip 29f400 and write ori flash into chip.
its a little bit expensive:/
Last edited by vicious425; 24th April, 2017 at 04:25 PM.
Just like the others say, boot mode is the first thing id go for, it's no biggie, you havent bricked anything, there are tons of ways to fix this. If you want, PM me and ship me the ECU and I will repair it for you for free as long as you pay return shipping.
AchtungPress the magic button
Bookmarks