Am missing something!!
It beep every 10 seconds and say Radio Safe!!
Using opcom tires deactivate anti theft protection but won't accept code!!
But when i try to activate anti theft protection code is accepted!!
Can someone help me to find solution!!
----------------------------------------------------------------------------------------------------------------------------
Don't confuse "Standing on my Shoulders" with "Treading on my Toes" ..
Ok i will try right now and post results!!
Unfortunately all the same!
Should i tired other diagnostic tool!!
All the same!
It beep every 10 seconds and say Radio Safe!
----------------------------------------------------------------------------------------------------------------------------
Don't confuse "Standing on my Shoulders" with "Treading on my Toes" ..
I have tried this but nothing!!
Can you explain me procedure of code insert!
Perhaps i do something wrong!
I know that i ask too much but if you have the time and strength!!
Many thanks for your help!
Procedure
=======
1. Install the new Radio (Unregistered)
2. Open OPCOM
3. Goto Radio Section
4. Press on Activate Theft Protection
5. Type the original radio password
(That came with the car, Matched with Display)
6. Goto measurement
7. See if the Theft Protection says "ID OK"
8. Turn off the car and remove OPCOM.
9. Now paired Display with Radio.
wbr
----------------------------------------------------------------------------------------------------------------------------
Don't confuse "Standing on my Shoulders" with "Treading on my Toes" ..
irfa (28th April, 2017)
Thanks for the procedure!
I was doing the same thing!
In theft protection says delivery state!!
Any clue what's going on here!
This means you have not Paired the radio... need to do this
See This:
Error Messages
===================
If you see "DISPLAY SAFE" permanently shown after 10 seconds,
this means that the Display has not been correctly programmed to the vehicle.
If you see "DISPLAY SAFE" flashing every 10 seconds, this means that the Display
is currently in Delivery Mode, and is now ready to be programmed to the vehicle
with a OBDII programmer.
If you see "RADIO SAFE" permanently shown after 10 seconds,
this means that the Radio has not been correctly programmed to the vehicle.
If you see "RADIO SAFE" and a beep every 10 seconds, this means that the Radio
is currently in Delivery Mode, and is now ready to be programmed to the vehicle
with a OBDII programmer.
wbr
Last edited by shooting; 28th April, 2017 at 02:16 PM.
----------------------------------------------------------------------------------------------------------------------------
Don't confuse "Standing on my Shoulders" with "Treading on my Toes" ..
Tomorrow will try with Tech2 and post results!!
I am extremely grateful for your help!
It is nice to see that there is good people in this world!!
Thanks SHOOTING!!
Yesterday i tried with Tech2 but still nothing!!
It wont accept code!
I had to deliver the car but it will come back in a month so i will try again but something else and post results!!
Bookmarks