Clio IV 1.5DCI UCH

[matrixpt]

hello everyone,

I've bought a Clio 1.5dci Mk4 with 14.000km on auction(The car have the fuse box completly burned and also the UCH module.

I've purchased from a crashed car, complete interior (wiring and all interior )and complete removal of all rusty parts from inside.
I've re-used all electronic componentes, except the UCH because it burned"... and i place new one..(from the donnor car).

Now when I insert the card on slot, and when i press start/stop buton, the starter runs, engine rotates but dont start (don't even exitate to start) - NOT START AT ALL.

Its possible to re-program("the used one from donnor") with Clone CLip?

regards.

[Bllinda]

Upload uch.ecu damp and look for p.i.n

[selim95]

in clio4 uch not coded with pin !!!!

[Bllinda]

If you can tell us how it works. Or where you can read about it? Thx

write to pm

P.S.

Here IV .... 2012 -
Here III .... 2005–2014

[selim95]

If you can tell us how it works. Or where you can read about it? Thx

write to pm

P.S.

Here IV .... 2012 -
Here III .... 2005–2014

immo -keys tec etc it's in ( module main libre )