To program you need PIN and some vag tool, even cheap vag-com. For PIN you can use various tools depending on car variant - sbb, fvdi, x100, vag tacho and many others.
To program you need PIN and some vag tool, even cheap vag-com. For PIN you can use various tools depending on car variant - sbb, fvdi, x100, vag tacho and many others.
Seby_TM (28th April, 2017)
If I understand corectly I need some tool for read PIN code from dash, immo box or ecu and after to program with vcds the new key with this pin for have access at programming sections ?
What name have this pin code and can be read with carprog ?
Thanks.
Last edited by Seby_TM; 28th April, 2017 at 06:20 AM.
Seby_TM (28th April, 2017)
Sharan is same like ford galaxi from 1995 to 2003 immo is location in immo box , immo box location under dash , read immo box and post here , someone give you the pin
Seby_TM (28th April, 2017)
Today made one, read code with t300, and program with x100pro
luck
Greetings dk
I forgot to comment, precoding with zed
Last edited by jaelgti; 28th April, 2017 at 08:54 AM.
Seby_TM (28th April, 2017)
Hi guys
Chinese sbb or ck100 can do these no problem. You may have to insist with the pin code reading, but it will extract it, then the programming process is same as any normal vag car for the immo, except that u use an id44. To add the remote it is done using the drivers door lock. If you need instructions on how to do this just give me a shout
Sent from my HTC One M9 using Tapatalk
Seby_TM (28th April, 2017)
Forgot to mention , chip precoded with fvdi2 tag tool. I always keep one precoded, because if it is unused it is unlocked and can be cloned. Faster than precoding
Sent from my HTC One M9 using Tapatalk
kamolsf (25th May, 2018)
Thanks until now to all, but exist another simpel solution to find securit pin for add fast new ID44 or immo off is more simple to do from ecu ?
Last edited by Seby_TM; 28th April, 2017 at 12:21 PM.
Transpondery.com there you got instructions guided
1. Ignition ON with 1st key
2. Get out of the car, close the door and insert second key into driver?s door lock.
3. Turn the key to the unlock position 3 times ( key must be held in open position by 1 seconds ).
4. Remove the key. The driver?s door LED will illuminate. Within 20 seconds:
5. Press and hold the lock button.
6. Still pressing the lock button - press the unlock button 3 times.
7. Release the lock button. Remote is programmed
I know, but the question was about 2003 year
Bookmarks