is that hybrid?if its hybrid you can do immo off ,but is very hard to unsolder eprom
is that hybrid?if its hybrid you can do immo off ,but is very hard to unsolder eprom
Silver740 (6th May, 2017)
thanks, yes hybrid. i can read 95020 on the board, but cant write file back. xprog says buffer error.
Last edited by Silver740; 6th May, 2017 at 01:09 PM.
we are unsolder eprom and program it on desk ,
Silver740 (8th May, 2017)
Thanks, thats correct. must desolder.
how do you remove the eprom from ecu
Bro,
If you are sure you read it, try to cut 95020 eprom pin number 8 and try to start your engine !!
If this doesnt work, then use my file and your car will start for sure.
Post result here bro !
Press Reputation +1 = Password in PM
regards
durdur (5th September, 2018), guuciek (5th July, 2017), MARIKO (24th November, 2017), publiperro (16th March, 2022), zeljko84 (11th January, 2018)
8 pin is vcc without it the ecu wont work at all
i have tacuma with the same eprom and ecu, have a programmer but i cant desolger it from its fuc..ng ceramics to read write
Last edited by satana; 19th May, 2017 at 07:23 PM.
Its very very hard to desolder the eprom from this ecu, I had took hours one day to clean - desolder it
When you fix it, keep us informed with the way you did it
regards
i was cut legs, then desolder back. And works. And unplug immobox.
Last edited by Silver740; 22nd May, 2017 at 06:13 AM.
desolgered it with the rework station
it should be heated
Hi Gkogkolos,
I've a probleme with immo off on a DEAWOO REZZO. It's a hybrid same a LANOS hybrid.
I make a immo off with immdec3.2 and disconnect immobox but not work.
Ca you send me the pass for this ?
****Lanos_95020 immo off tested gkogkolos****
Thanks in advance
Hello,
no one to help me?
Bookmarks