maybe the remote byte from the key has been damaged.
Got mercedes w639 2005 with key not turning. Gave esi to somebody who repaired hash error and programmed keys. Now the car starts ok but the central locking does not work from the remote but ok from button inside. Customer says that previous to this it would not open with the remote first time in the morning but would work from remote for the rest of the day. But now , after esi hash repair, it does not work at all from remote. customer took car and had it diagnosed by a mercedes specialist and was told its the esi at fault.
Appreciate if somebody can look at the attached files to see if the hash correction is done ok and if this is the cause of remote locking not working and way forward for repair.
thanks
VITO W639.zip
Last edited by yusef; 16th May, 2017 at 11:59 PM. Reason: attachment was in middle of last sentence
maybe the remote byte from the key has been damaged.
yusef (17th May, 2017)
yusef (17th May, 2017)
Thanks guys
Programmed two more keys and same , all keys start ok but central locking does not work from remote.
All keys have IR and radio frequency. Remotes seem be good, how do i check remote bytes ?
Is there a separate receiver for remote signal ?
Guys in your expert opinion could this be esi fault ?
you can check if remote is transmit with a remote tester.
the connector on the rear of the eis is for the remote.
with what programmer you program the keys with?
autodiagdoctor (3rd February, 2018), yusef (18th May, 2017)
Could be EIS fault,and could be wrong frequency of keys as well.......
Guided fault finding = Feature that many factory scan-tools have and real technician despise it.
autodiagdoctor (3rd February, 2018), yusef (18th May, 2017)
Checked key IR,RF and frequency ok on keys
EIS part number is 639 545 01 08
Cant find used with this number - is there an alternative part number that can be used e.g. 203 545 05 08 ? looks similar
yusef (18th May, 2017)
I know that this could be too simple solution but check little connector on the back of EIS, must be connected, some time ago i made this mistake
yusef (18th May, 2017)
checked all connections, cant see anything obvious, anything inside esi to test ?
what needs to done when replacing esi
When replacing eis...
Get same part number and simply use programmer to write eeprom file to new eis.
All key data will be transferred to new eis.
yusef (19th May, 2017)
maybe problem with antenna, for example on W203 it is verry often...
yusef (19th May, 2017)
which part is the antenna and how to test and repair ?
thanks guy for all your continued help, its a learning curve for me
I guess I need to remove my EIS and check for the connection there. Past couple of days I have been scratching my head as to why the remote central locking does not work!
MPPS Standalone Master, Magpro Base + X17, Dimsport New Genius, Piasini, Galletto V53, Kess V2, K-Tag, Trasdata remapping tools | OP-COM, VCDS, Fiat MultiECUScan, Ford F Super, Renault CAN Clip V124, INPA/NCS Expert + others.
Check the key in ignition switch. If it is not working properly and thinks key is still in ignition, then remote wont work. Is the esl engaging when you pull key out?
Bookmarks