Just swap eeproms if you have the same HW number, via eeprom only virgin sollution, for total immo off read flash and post it here.
Just swap eeproms if you have the same HW number, via eeprom only virgin sollution, for total immo off read flash and post it here.
mscauto (26th June, 2017)
Hi, the ecu label has been worn away and I only have some of the numbers. I cant read the bosch numbers at all. I have tried changing the chips over but it did not work, the injector light was flashing and wouldn't start. I couldn't get a read from the flash using bdm reader. Maybe I will try again. I thought i had read on dk that immo off in eeprom was possible.
iveco.daily.2004.twydall.250617off.rar your off file .. you have to recode injectors after
mscauto (28th June, 2017)
Thanks for the file. I will try it today.
I programmed the ecu and fitted it back to the van today. The van didn't start, it turns over fires and cuts out. The injector light is flashing. I forgot to unplug the immo box before turning the ignition on, is this a problem? I also cant program the injector codes as its got the round diagnostic plug.
Your ecu is a C8, not C39, my mistake, now write original flash back and put the file I just uploaded into eeprom, tested 100%...good luck!
mscauto (29th June, 2017)
Bookmarks