Luis Jaued (14th October, 2019)
Hi,
I have Audi Q7 4.2 FSI 2006. ECU MED9.1.1
My original ECU is broken (water is inside). I read ori ECU by BDM. Flash and Mpc is OK, but EEP - only 00.
I read 95160 by programmer, but when I write flsh, mpc and eep, or only eep (read by programmer) to the second ECU I have ecu error and the car doesn't start..
I think my ori EEP is broken (I compare it with other ones).
I need Immo off NEW ECU or transfer immo data from ORI -> NEW EEP.
Tnx.
Luis Jaued (14th October, 2019)
waldi1979 (29th June, 2017)
Hello @waldi1979
Have you tried the eeprom? Did it solve problem?
Regards,
hi try these two files the eprom and flash and replay
the immo is off of your new files
waldi1979 (30th June, 2017)
by the way only eprom immo off or write will not work need the flash to be immo off as well
try the one i give you dear and replay
you need the file which i give you eprom and flash to write and replay me then i can help ahead if some problem occur
and before to write the eprom and flash i gave you try to read the eprom and flash again to keep the new ecu data safe with you once more
SAFE on display and 1 spark after connecting ECU.
make new transponder and learn to the car and start the car
first learn the original key to the car if not work make new transponder
Last edited by ZAHEER; 1st July, 2017 at 03:28 PM.
Probably my "new" ECU or the car is damaged. Now I have only thottle error . I managed to start the car twice but after turning the engine off it wasn't possible to start it again.
I order anothet throttle...
Hello, What ended your story? I have a very similar case
THANKS + REP if I help you
Bookmarks