I would not bother sending it to Germany i had an old ET9000 model same as the 9200 apart from cosmetic differences, They basically sent it back as parts are no longer available.
Time to move onto a different receiver
Hi, I would be very grateful for your help regarding a problem with my Xtrend 9200 receiver.
Since last week, upon startup, i am unable to receive any channels. I have a 'Tune failed!' message appear
on screen. After switching off then on again i get the same problem so i am unable to receive any channels.
The same problem exists after i flash different images.
On a couple of occasions having left the receiver on a channel where the Tuner A indicator appears in green (not yellow)
i have found after many hours that the channel is received. Unfortunately once i switch the receiver to standby or sometimes
change channel i get the 'Tuner failed!' message again. This problem continues and i cannot receive any channels now.
I read there is an address somewhere in Germany where i can send the receiver to be fixed. Does anybody know is this is correct and what the address is please?
Many thanks if you can help me.
I would not bother sending it to Germany i had an old ET9000 model same as the 9200 apart from cosmetic differences, They basically sent it back as parts are no longer available.
Time to move onto a different receiver
satlover276 (30th June, 2017)
Okay i understand.
Last edited by satlover276; 4th July, 2017 at 04:12 PM.
Hi There
I actually had this also.
I basically in the end factory reset it and started again and it worked
Definitely, reset it to factory settings helps in this case.
It's a rather old and cheap tuner. I would just ditch it and buy a better one!
Bookmarks