ZAFIRA B 1.7DTR 2012 not power up DASH , DIS and not crank

[mexanico1971]

HI
Got this Zafira B from 2012 that came from Opel dealer , and other expert in Electronic management.

The car not crank and i can"t not diag CIM ,SDM ,ECC,IPC , DIS
I have diag width ECU , immo ,
I have this DTC

B3840
B3925 IPC
B3929 REC
B3977 UEC

U2113 SDM
U2116 IPC
U2117 DIS
U2140 UEC

Any ideia

Thank"s in advance

Brs

Oh !
Another thing
Is possible by VIN know what this car bring ? epc . cruse control e.t.c ?
Because I have to code the High CAN , middle and Low .

W0L0AHM75D2057373

This is the fuse box , version A
https://www.youtube.com/watch?v=GtdIu4agsSY

[Dunker]

Is this the one like the Astra J with the battery top 8mm fuse connectors that get warm and melt the plastic around the connectors making a shitty connection because of the right good design.

[mexanico1971]

HI Guys
I got the car at my garage
And fany thing append wend I try to diag IPC width OPcom , the ligths on dash came up , so I start to think this is a CAN-Bus problem
I only got opcom 2010 ,139fw any one try the the opcom Software 2014 in Zafira B 2012 up ?!
Does it connect to all modules
I still got no connection to UEC
Does any one have some sheme for this car ?!
Thank"s in advance
Brs

[radiosolutions]

Op com not very good on newer vehicles like insignia , astra j, new Meriva. Mdi2 is needed for these m8

[mexanico1971]

Hi Folks
I have examined configuration of the car , and the UEC letters aren"t compatible width others modules .
So I decide to get another used , but I can"t know the pin width shore
I read the 95080
Can some give the PIN please ?!

Thank"s in advance

[drahe]

..........9459............

[feketezsolt]

Change it the cim module this is the can gateway. its common opel problem

[mexanico1971]

Change it the cim module this is the can gateway. its common opel problem

HI
CIM now is Good
Now IPC is the problem
Does any one manage to read D080wq width carprog ?!

Thank"s
Brs

[mexanico1971]

Hi
I take the IPC in pieces , and check the PCB and found one capacitador is missing the one near the D080wq , so I put one and Voila , IPC is live again !
But LCD ribbon is Break
So now car crunk , I got no DTC"s in ECU ;IPC ; IMMO and CIM .
BUT i don"t got 80v in the Injectors Or Denso sistems are different ?!!
In diag Sw I can see injection time and quanty
How to see if injectors are not dead , they have 0hms between the 2 pins , and In plug width engine crunking 0v !

Any ideia

Thank"s in advance
Brs

[mexanico1971]

..........9459............

This "new" one have the eeprom new the processor
Brs