hello can it read and write mv1746 isn ? of e90 320
wbr.
This tool is faster on AKL FEM IMO. I’ve got IM608 and the preprocessing steps along with the programming is more time consuming. I have learned a few tricks with this tool. One thing it will do is revive a dead FEM if the FEM is relay is constantly clicking. All you have to do is go into the F/G series programming tab, click on the FEM, then connect the EEPROM adapter for preprocessing to VCI with +12v adapter plugged in. Now connect the EEPROM adapter/clip to the 95128 eeprom. Follow prompts on programming. When the FEM stops clicking, remove EEPROM clip from the FEM and let the tool program the FEM. Now you can go and program the FEM as needed. Hope that helps because I know I had a tough time learning about FEM/BDC programming.
p1et (8th April, 2021)
I bought them on eBay. They arrived in a day or two. Good service.
https://www.ebay.co.uk/itm/192791759254
Have a look here on new update ... zf6hp isn e series
https://youtu.be/OLWzW1qD6Go
wbr.
This one for version not supported .... 8hp f series ... https://youtu.be/4hH2eQHqjto ... if somebody do downgrades please record and upload
Last edited by hesham10; 31st October, 2021 at 09:44 PM.
wbr.
CGDI Prog BMW is it possible to run the program without interface? if so, how to cheat it?
mercedes CGMB program, you can
I bought a BMW CGI Prog for mileage correction, but I could not reset the CAS3+ on the e70 2010.Why if it is stated that there is a mileage reset?Disappointed
Bookmarks