you trying to read with an adaptor clip?
solder to a board and it will read
Hi!
I do have an Airbag Module from Opel Corsa D Temic 13 283 819 and want to remove crash data.
The car has an accident at front but the Airbags hadn't blow up. Despite this when I connect the auto to diagnostic tool some airbag fault come out.
When I open the module and unsolder the EEprom 95160 I cannot read it ;/ ;/ ;/
The Carprog in Airbag module shows:
[12:07:19] Reading chip...
{!} ID not found
when i go to read/write it shows only:
00 00 00 00 00
I tried also to read it with USB-UPA. In USB-UPA if i check connections, everything is green and OK, but USB-UPA also read this EEprom and shows:
00 00 00 00 00
1. Any advice how to repair it?
2. Is the Eeprom or dump broken?
3. Probbalby You have any oryginal dump without crash data to write on it?
4. Should I write on new EEprom or use this?
Thank in advance
you trying to read with an adaptor clip?
solder to a board and it will read
kubuswujo (12th August, 2017)
When I try read with Carprog I use clip, but unsoldered from Airbag module.
When i try to use with USB-UPA then I solder it into adapter for 95xxx series.
while using USB-UPA it shows Veryfy status OK and thats starange... Which Voltage should I use? 3V or 5V?
have already readed the EEprom can someone look if its ok and clear crash data?
Last edited by kubuswujo; 14th August, 2017 at 09:59 AM.
HERE YE GO TRY AND TEST
Thanks for your file without password
Bookmarks