Reply With QuoteI had the same problem with one recently. The ETL worked OK on two other MCUs of the same type that I had at hand so put it down to a fault in the MCU I was trying to read. Also read in documentation that the MCU can be corrupted by removing the adaptor without powering it down first, which I had done. *oops*
Eventually got it to read and write after multiple attempts where the others would read straight away - No real idea of why.
Results 1 to 4 of 4
Thread: etl hc908
-
21st August, 2017, 12:22 AM #1DK Veteran
- Join Date
- Aug 2016
- Posts
- 327
- Thanks
- 171
- Thanks
- 34
- Thanked in
- 31 Posts
etl hc908
Goodbye to all
I have a problem connecting my tel on my pc it gives me a firmware update message interrupted
-
21st August, 2017, 03:08 AM #2Top Poster
- Join Date
- Aug 2010
- Location
- Ozbloodystralia
- Posts
- 119
- Thanks
- 36
- Thanks
- 19
- Thanked in
- 17 Posts
-
22nd August, 2017, 07:53 PM #3DK Veteran
- Join Date
- Jan 2016
- Posts
- 1,167
- Thanks
- 808
- Thanks
- 396
- Thanked in
- 279 Posts
As I know old ETL for 908 works only on WinXP... ?
-
11th February, 2018, 10:41 PM #4Junior Member
- Join Date
- Dec 2017
- Posts
- 34
- Thanks
- 39
- Thanks
- 0
- Thanked in
- 0 Posts
Tried on XP, same problem. Trying update firmware but " check sum not correct, try's no again" forever. After terminate, the programmer no longer detectable in working mode.
Is ir brick ?
Bookmarks