Ok if it is not possible to make IMMO OFF in this ECU, how to solve this problem:
ASTRA H once starts normally, once you have to close and open it few times then it starts.
When it not starts then IMMOBILIZER Light on dash is on.
The Fault code is:
B3055 - No TRanspoder/ No Key present
I understand if it not works at all but sometimes it works and sometimes not.
So i think that if i code Pin once more to same transponder then it will be the same. Now for example it is still working.....
kubuswujo (31st August, 2017)
CIM friend, check solder points, fix if needed or change and program ...on second key also this faults ?
You use srs units files at your own risk. I am not responsible for any damages. Don't ask about passes, one file=one pass.
If I helped, please, use magic buttons reputation+thanks.
Best regards.
Dragon
kubuswujo (31st August, 2017)
DTC in CIM module is:
B5055 -No TRanspoder/ No Key present
The user have had problems with Generator and was driveing the Car till battery is empty.
I have seek on the internet and find out that I should FLASH the CIM module with newer version of software (2005-2007 bad software, 2008>>> good)
I should do it with TIS 2000 DVD and oryglnal TECH2 or MDI
I do not have MDI interface for flashing CMI can someone tell if Clone is ok? do You have any good clones of MDI?
Do you try to read key with mey mashine?
no I do not have any key mashine i do not do new key's and immo.
Bookmarks