someone that make this with dgp3 clone ??
hi , i try recalibrate dash in Peugeot 307 years 2003 with DGP3 and adapter st59 but always give me this error ..... PINCHECK
dgp3 error.jpg
i use this pinout
IMG_9407.JPG
pin 2 y 11 need lift of Pcb and solder The wiring or Only solder in The pin ???
Thanks
Last edited by m35i; 20th September, 2017 at 02:37 PM.
someone that make this with dgp3 clone ??
Yes 2-11 pin must lift.
That pinout is not correct
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
ONLINE CAR FILE EDITION SERVICE
SERVICIOS DE EDICION DE ARCHIVOS AUTOMOTRICES
use this pinout:
307 nec ok.jpg
Good Luck!
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
ONLINE CAR FILE EDITION SERVICE
SERVICIOS DE EDICION DE ARCHIVOS AUTOMOTRICES
but this pinout is for dgp3 ?? or any nec programmer ??? with this pinout need lift pins ???
yes i try but not read with pinout of dgp3
Dgp3 Clone it `s not good on nec...
jomberykaso (21st September, 2017)
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
ONLINE CAR FILE EDITION SERVICE
SERVICIOS DE EDICION DE ARCHIVOS AUTOMOTRICES
not work i think that this adapter is very bad for this work
Bookmarks