at least the oil is good
oilgoodnew.jpg
Coul it be that something is wrong with starter control and when keys is registered car must be started to confirm and close programming mode?
A i was able to start car suplied 12 to starter control whey keys was registered. Car started. But when i shut it ofc. Next ignition on is immo light is on agai.
Cant figiurout wheres problem.
at least the oil is good
oilgoodnew.jpg
Please hit the rep & thank buttons if this post was helpful!!!!
Last edited by Duracell2; 17th October, 2017 at 05:17 PM.
Please hit the rep & thank buttons if this post was helpful!!!!
I understad jokes . No problem.buddy but yeah its stress when car comes by it self and things like this happens. Ownear calls few times a day. Asking its yet . Done. Hows going etc. Tried 3 tools to program and add key by dump. All same. Tomorom will try fvdi. If no luck. Than dont know. Maybe will try looking for "starting" kit.
was my mistake. I had change to make copy with handy. But NO wanted to try by obd. And now im.dreaming not starting qashqais at night
Duracell2 (17th October, 2017)
I used 3 tools. With all same problem.
I have saved dump. But dump was readed already after problem occured.
Tomorow will try fvdi.
Ive tried maxisys. Ck100,pad2. All same. Immo light turns off but no starter.
Tomorow will return old dump. Ive read it . In dump was 1 key.
You Must get good tool for this car like nissan consul or g scan 2 or some more expensive tool Avdi or zed full , i was try make key for Nissan Qashqai with SKP900 and FVDi without success and after i get G Scan 2 and success so get good tool for this car .
I will surely will not buy tool for 3-4k to do this car its not an option.
I will surely will not buy tool for 3-4k to do this car its not an option. How about consult 3 clone? They are working?
Car is still in learning mode.
You dont need to spend 3k to 4k to do keys on this car , original truecode with NTC2 licence should do these and is reasonably priced , G-scan tab is also capable of doing these and is around £900 , so 2 options that are far cheaper than avdi or zedbull that will also do these .
cheapest option may be to pay someone with the kit that does do this to come and do it for you
Being keyless start model one key should be well away from the car when programming, bring one key at a time in the car. Check if key is locked or cipher ? a lot of tools cant programme this smart keys. Try mvp, use rke function to programme remote side. When asked to switch ignition of and cycle keys, try switching ignition to position 1 and back to 2 with original key only and see if it registers.
hope you get sorted
hi just a question
i use ez500 xtool never had a problem with adding keys or somthing like that
when you read the bcm you get 5 numbers
use calculator then you get 2 number at least i do !
is it maby possible you use the wrong pin code ?
give me your bcm number let me see what i get maby its possible you use wrong code
i have seen that happen with some of my cars
kind regards mehmet
Bookmarks