GAMBIT............car-prog not testet
Hello DK,
I tried to program a chip to a 1997 Mercedes yesterday. Took the HC05 chip off the board, read the data, put into Tango to make a chip... Noticed that all positions were full... In the past I have run into problems using a used key position.. tried position 1 and also position 8.. the car starts and then shuts off... Does anyone have the ability to make any of the key positions not used???
Thanks in advance....
GAMBIT............car-prog not testet
Last edited by szengen; 16th November, 2017 at 12:12 AM.
fang, Narwalus microcephalus,Spectrum Zx, Atari amiga, Commodore +4
Sorry... are you saying I should use GAMBIT??? haven't heard of that...
Gambit or TM100 work good for old Benz 7935 key
Be polite. No Thanks + Rep, no HELP!!! Slava Ukcraine. Dead Putler civilians's killers!!!
Its there a light in the mirror RED and GREEN
Verzonden vanaf mijn iPhone met Tapatalk
You can prepare auto programming chips by avdi, miraclone... after that just insert the key in to ignition it will program by itself
no lights in the mirror.. just a light in the radio bezel... Tried programming a key with AVDI, didn't work... Used Tango, didn't work... put the bin file into the AVDI dump tool and it virginized the file, all the key slots are not used now, but I don't know if it striped all the data from it... and if it did, how to I resync the immo to the DME.... Ah, fun with old mercs...
try this file without transponder and report!
b.r.
Thank you Icogsm... I will write to chip and try tomorrow..
Thanks again...
Bookmarks