this is my home made diga
this is my home made diga
Col19 (26th December, 2019)
well done mate !
Must have been a hell of a job.....
Yeah it was. When I buy my diga clone from china, back in 2007 it was roughly about 1000euro. I open the package and surprise I get a piece of shit. My handheld only power up and nothing else, all other module was defective also. After mounts of repairing and trying to understand how it works I decide to build one, to have for backup and for software test purpose.
Last edited by tehnosoftex; 21st June, 2011 at 10:41 PM.
fluorescent (8th August, 2017)
good you did a great job
Micronas OBD TOOL (CDC32XX) or VAG KM+IMMO TOOL BY OBD2 ??
Who knows about it ?
Last edited by lukylucienn; 2nd July, 2011 at 03:43 PM.
VOLVO DiCE:
Does anyone know where I can mount the Bluetooth module?
this is the eprom's 12C, SPI, Microwire. adapter i made for UPA USB.
i will make a Microwire Rotated adapter soon.
gameiruz (1st September, 2014)
@Holtek
There should have been a 40-pin Hi-rose connector near the middle of the board in your second picture.
The module should be supported at the hole near the edge.
Thank you for the information. Do you have photos of DiCE with Bloototh module installed? Can you upload? Does Blotooth module can buy somewhere?
I got an interface to the car, but I do not know what kind of cable. Can anyone tell me by looking at what kind of interface, and what program to use it?
Plug into your computer via RS-232.
I checked and it is a cable CLONE VCDS.
Plugged with the installed version 704.2PL and working properly. Thanks everyone for your help.
Detects: Ross-Tech HEX-COM + CAN Version 1.78
Last edited by pomocrtv; 25th July, 2011 at 08:56 PM.
I gave up.
Last edited by morfej; 17th September, 2011 at 05:00 PM.
Bookmarks