Hi ,
yes , the new function added recently for Tango BCM2 can make key by Dump ready to start .
Hi ,
yes , the new function added recently for Tango BCM2 can make key by Dump ready to start .
you have two choices in the morning: go back to bed and continue dreaming, or you get up to make your dreams come true
bonecrusher (12th December, 2017), doctore (11th December, 2017), p1et (11th December, 2017), trinicolin (11th December, 2017), yugo45 (12th December, 2017)
Great!!!!!
Sent from my SM-G930F using Tapatalk
You will not read nec without immo soft. So to make key you have to pay 380eur.
Did you test it what you say? Look tango forum. You need immo hpx soft for 300eur. To read correct size data.
rob h (12th December, 2017)
Even with Orange5 immo hpx and Tango to do this job it's very economical compared to other methods.
Sent from my SM-G930F using Tapatalk
Sent from my SM-G930F using Tapatalk
bonecrusher (12th December, 2017), doctore (13th December, 2017), rob h (12th December, 2017), topclef (12th December, 2017)
Orange5 +Immo-Hpx it's not just for reading and writing BCM2 , even if you'll bought one and I suggest you buy one , you never regret
you have two choices in the morning: go back to bed and continue dreaming, or you get up to make your dreams come true
The orange-5 itself, 350
Immo HPX 8V0, 300
Bcm2 licences tango 80
Vat and shipping excluded.
And this does what, all years? And all, even those without eeprom?
I understand the advantage of owning a good programmer.
I allready have upa xprog and vvdiprog, so what does this bring to the table?
orangev1.34
Immo HPX 9V0
BCM2
Ver.1 uPD70F3239
Ver.1 uPD70F3380
Ver.2 uPD70F3380
Ver.1 uPD70F3634
vvdiprog
3379
3380
3381
3634
Last edited by rob h; 12th December, 2017 at 05:52 PM.
Orange5 with software Renesas/NEC V850 UART HPX has a lot more protocol. Can also read BCM2 file to sync to car not only key maker.
Sent from my SM-G930F using Tapatalk
rob h (13th December, 2017)
Besides the emergency key, yes, the remote and transponder will be programmed.
Making sure that you have the correct mzh.
amigokola (13th December, 2017)
Yes, remote will work. Not working? Bad conf in key, incorrect freqency
p1et (14th December, 2017)
can anyone load my files to check in maker if its accepts good. d flash p flash
Bookmarks