New transponder x prog china be carfuul ,Smok j tag can do ,best people say is etl .
hello, i have a mercedes sprinter 2.2L, year 2004 and after the battery died and put a new one i have in dash start error and don't start. Can anyone tell me what should i do. I have the ecu 0281011745, the immo box temic with 2L52H. In immo killer said to load only dump from temic HC08. It is ok or need to read the ecu to? For reading 2L52H what should i use? thanks
New transponder x prog china be carfuul ,Smok j tag can do ,best people say is etl .
Carprog / Gambit , carprog read ECU 95P08 and you need virgin line: ID0-ID4 write 00.00.00.00.00 or 02.03.00.FF.FF, carprog read Immobox 2L52H and line: 120 write keychip info, gambit read chipkey info Temic12...
5P08C3.jpgXprog-Temic12 sprinter.jpg
I think AVDI do this...
Good morning before complicating your life, if it is for a change of battery, check the fuses, if all are correct, disconnect the battery, with the terminal disconnected, ative consumption, example lights, light breakdown, ..., for about 2 minutes, this will unload all the system and ECU condensers, then turn off everything and reconnect the battery, it should restart the communication between ecu and immo
It is usually a common failure, and several I did, it must start
[QUOTE = daniteixeira; 3194516] I think AVDI do this... [/ QUOTE]
Yes from OBD2 , DLC , Mercedes adapter, without disassembling or replacing anything , just with synchronize
regards
Last edited by Talleresmalaga; 21st January, 2018 at 12:51 PM.
AVDI or FVDI chine work 100% do this...
Julie Emulator + modified ecu eeprom + removing can-filter from WSP = 100% success
The original author of Siemens Simtec 70/71, Delco HSFI-2.X and Audi Multitronic repair instructions.
Bookmarks