Leave the key on for a few minutes till the light goes out, then cycle it again, then second key.
You have to have 2 keys for all keys lost.
hello friends
pls i have a problem with ford escape 2009 we loss all keys and we try to program a new key i dont know which mistake we did the car enter in anti scan mode the security light is blinking quickly when i open ignition
and when i try to program key again it show can not communicate
thanks for helping
Leave the key on for a few minutes till the light goes out, then cycle it again, then second key.
You have to have 2 keys for all keys lost.
Last edited by clusters; 14th January, 2018 at 08:15 PM.
Please DO NOT PM me asking for help.
Post in the forum, that is what it is here for.
i am not sure if the key was programed or no as now i cant connect the programer to the car and i leave the key for few minutes till the light goes off and cycle the other key without success any other way to exit the anti scan mode and connect to the car again ?
thanks
So you are saying it is still in anti-scan mode with the theft light flashing?
If so, key one turn ignition ON wait till theft light stops flashing, key OFF.
Still key one, turn key ON for 5 seconds (should be solid theft light), key OFF, key two ON (should be solid theft light) and after a few seconds the theft light should go out.
Your two keys should now be programmed. They need to be two different keys, not clones of each other.
You should also be able to disconnect the battery for a few minutes to reset everything and start over of needed.
After that I have no idea.
Last edited by clusters; 15th January, 2018 at 06:12 AM.
Please DO NOT PM me asking for help.
Post in the forum, that is what it is here for.
cyril (15th January, 2018), ucokseparoh (19th January, 2018)
Where you able to sort the car?
Always show appreciation to ur helper NO + THANKS = NO HELP
i didnt try it yet i will try Clusters method today
thanks
What scanner are you using?Also you said you lost all keys,therefore no key is programmed , so I think you need 2 new keys not one to be able to enable programming of the new keys I use ford IDS online to do this job .I find it more stable .
Sent from my iPhone using Tapatalk
hello it didnt work and i try whith launch and with avdi it show like it the key was not programed good last time and i try to open ignition and wait when the security light is off after 2 minutes nearly of ignition open but still the same
help pls
Last edited by cyril; 17th January, 2018 at 07:53 AM.
any help plsss
any other way to exit anti scan mode for this ford escape pls ?
already told the companion above, disconnect the battery and leave it a few minutes, if possible, with the battery disconnected, turn on lights or to boot for a few minutes, to download the entire system and the condesadores, after a few minutes turn off all of new, and reconnect the battery
The system should be reset
i try it and remove ecu till next day and put it again and leave the car without battery and still the same any thing can we do it in the dashboard ?
Bookmarks