Bad reading. Best way is to desolder.
Hi all I wonder if some kind member can assist with where i'm going wrong trying to read and write this smart sam unit please from a smart roadster 2004 I am having trouble reading correctly smart sam with upa and vvdi prog. Upa read correct but the file size is incorrect. I have used connections posted by member Pipnina(Thank you) on here and have virgin flash ect but when I try reading flash I only get 64kb file I know should be 2048kb. I have lifted pin and had to put link wire in due to it being knocked and lifting a pad on the board. Btw genuine upa. Here are attached dumps
IMG_3699.JPGIMG_3698.JPGmodded.jpgIMG_3702.JPG
Eprom - This looks okay
flash - wrong size and not the same
flash 2 - wrong size and not the same
Flash V0.13 Flash from this forum notice 2048kb mine is only 64kb.
Also images attached.
Last edited by Galee; 12th September, 2017 at 01:18 AM.
Bad reading. Best way is to desolder.
ahh yes but many people have read these with out desoldering mcu any ideas?
http://www.digital-kaos.co.uk/forums...smart-roadster
And io terminal or Smok, by Obd maybe.
Cheers buddy did read that thread already got a xprog 5.5 here I'll take a look good to know terminal io can do them thanks for the info.
I have tried with these connections still no joy this is with upa
Anyone got any other ideas or connections how I can read and write this sam with either upa orig or xprog clone or vvdi prog?
Hello , you need to use 3.3V in UPA , this kind of MCU use low voltage for working .I think your UPA gives bad contact on VCC , corect ???.Also check your wiring because connection from forum MUST work in circuit .
Hi guys sorry to revive a old thread but still got this car and still having trouble with this sam . Okay today have tried with vvdi prog please find attached dumps. Can anyone help me with this??
Cheers
Galee
Bookmarks