hi, test and report glow plug
hi, test and report glow plug
mislav88 (21st January, 2018)
thank you but i still have P1395, P138b and car in limp mode, wont rev over 3000rpm
test glow plug control
injector registered ????????????????????
Last edited by sonic 1989; 21st January, 2018 at 11:13 AM.
mislav88 (21st January, 2018)
have you checked glow plugs?i had same situation with cmax and i fixed it with 4 new glow plugs
mislav88 (21st January, 2018)
problem is not with glow plugs but glow plug system, wiring is from a car with only glow plug relay, ecu expects to find glow control module which isnt present
injector coding is ok, cheched with ids. when i erase faults after i turn ignition on and then start engine, i can drive normally without limp and mil until engine is shut down again and restarted.
- my versions 2 did not help ????
egr glow- 1037374715.rar (371.0 KB, 1 views)
mislav88 (21st January, 2018)
no, i managed to get rid of P138b with switch at 1CB1D4 but still limp mode with P1395
egr is ok with your file
Last edited by mislav88; 21st January, 2018 at 05:17 PM.
You have to switch off the glow plug system. Removing dtc only is not the solution. No dtc but limp mode
hi
try with this file
mislav88 (21st January, 2018)
switch off glow plug not work.............. if they file not work write to me, I do to any problem.....
FILE SERVICE
thank you guys i managed to get rid of glow plug problem with a file from another car, now i believe egr is my problem, i have dtcs and limp mode
P1412 EGR valve frozen
P1635 tire\axle out of acceptable range
hi,your egr off+ maps dtc code obd and class
Last edited by sonic 1989; 22nd January, 2018 at 11:36 AM.
mislav88 (22nd January, 2018)
with your file no dtcs but still limp mode and MIL flashing on dash
Bookmarks