Passat b6 CCM adaptation

**kidloco** · 19th February, 2018, 10:02 AM

hello on passat b6 2006y is ccm died no remote control working and no ignition .i am found same ccm same number and swap eeprom 95320 but still cant give igintion. i found new ccm esl and key from crashed car and now i can give ignition car is cranking but not start immo is active
so i need solution to adapt only ccm new with old eeprom inside or adapt ecu to new CCM .. please can someone help how to do it .. i have vcds and fvdi...thank you

**brend** · 19th February, 2018, 10:13 AM

Put CCM and Ecu dump.

**kidloco** · 19th February, 2018, 10:26 AM

hi ecu is simos pdd 1.2 BKP engine code, fvdi dont let me read this so i cant get ecu eeprom i never open this ecu but i have read that eeprom is not easy to get in this ecu..

**brend** · 19th February, 2018, 10:33 AM

Ok put both CCM dump.
Need look at this possible data exchange or not.......

**kidloco** · 19th February, 2018, 10:52 AM

ok i will .. thank you for help it think my ecu is on waiting time for read and i had forgot where is chanel to see how much time i had to wait with vcsd .. if i read ecu dump via fvdi i will only get cs and pin not whole dump is it ok for you...???

**brend** · 19th February, 2018, 11:04 AM

Originally Posted by kidloco

ok i will .. thank you for help it think my ecu is on waiting time for read and i had forgot where is chanel to see how much time i had to wait with vcsd .. if i read ecu dump via fvdi i will only get cs and pin not whole dump is it ok for you...???

Eeprom dump need full format.
I dont know how much read fvdi.
And FVDI.????????????
Better if you read this eeprom in programmer not with FVDI.