Pezhoo (24th August, 2023), rumensivanov (23rd February, 2019)
Pezhoo (24th August, 2023), rumensivanov (23rd February, 2019)
The corect file is Size: 896Kb and yours 832kb ???? try reade again!! to virgin ecuvonix!!!!!!!!!!!!!
Uploade file here to help you
Regards
Nikos
Last edited by nikostzimis; 19th March, 2018 at 03:47 PM.
I found another post and size is same. look:
http://www.digital-kaos.co.uk/forums...ISTEON+DCU+102
http://www.digital-kaos.co.uk/forums...ISTEON+DCU+102
Try to read with K TAG and ORANGE-832 Kb
With VVDI lengh is same-832 kb.
May be i make mistake?
yes...
I have original immo decoder 4.5 i try to vrgin file but tells me the file is not correct!!
checked kb Galletto?????
Look this
http://www.digital-kaos.co.uk/forums...2-in-boot-mode
I think to help you to read correctly 896kb With Galletto v54!!!!
R...s
Nikos
Last edited by nikostzimis; 19th March, 2018 at 05:55 PM.
ilian_cho (20th March, 2018)
artangjepali (5th July, 2022), ilian_cho (20th March, 2018)
For all: File DCU_102_virgin_2 work. No need injector coding no need pump adaptation. My problem was water in ecu conectors. Thanks to BALTAZAR3 and NIKOSTZIMIS for the help
And for all that have problem with size: Flash in ST10F276 is 832kb read with oranfe vvdi k tag even x prog. When is readed with galletto size is 896kb. but after adres #CFFFF no data only FF FF .......FF. So important data is betwen 00000 and CFFFF.
tecnocar (19th December, 2019)
then biscuit reads the complete info without cutting the file size (delete data)
THANKS friend Ilian_cho
IT WORKS PERFECTLY
Last edited by tecnocar; 20th December, 2019 at 04:36 AM.
Bookmarks