yes you must precode.a lot of that is on the forum.
I have a card for renault scenic / megane II used. I exchanged the transponder (PCF7947AT) for a new clean one and programmed it. The car is starting but the remote control does not work. The remote control sends a 433MHz signal.
Why did this happen? Do I have to use a pre-coded transponder?
Last edited by oliva; 21st March, 2018 at 08:06 AM.
yes you must precode.a lot of that is on the forum.
oliva (21st March, 2018)
Thank you friend. And can you do it zedbull clone?
yes zedbull also, like LION0304 say.You must use option HITAG 2
oliva (21st March, 2018)
Is it done the same in Scenic II as here in the description for Laguna?
http://www.key-programmer.org/2016/1...-with-zedbull/
joe06 (24th March, 2018)
Precode for megan 2.
Last edited by triak88; 21st March, 2018 at 09:29 AM.
Bookmarks