Reply With QuoteI had the opposite , UPA-usb couldn’t program a chip so I programmed it with carprog.
Try different programmer.
or maybe mcu memory is locked ?
Results 1 to 7 of 7
-
27th April, 2018, 01:04 AM #1Senior Member
- Join Date
- Jan 2014
- Location
- Michigan State USA
- Posts
- 297
- Thanks
- 5
- Thanks
- 53
- Thanked in
- 34 Posts
2016 nissan murano infineon airbag -security access error for carprog
i have airbag module 98820-5ac0b.
try to read it via original carprog on table
i keep getting error: means wrong softwarwe- used all nissan models except rogue
rogue 2015+ is n/a
security access error
turn ignition off for 5 sec.
turn power off for 5-10 seconds and for 1 minutes
same issue
any advises
thanksLast edited by KALNAJJAR01; 27th April, 2018 at 04:22 PM.
-
27th April, 2018, 02:14 AM #2DK Veteran
- Join Date
- Jul 2016
- Location
- USA
- Posts
- 1,278
- Thanks
- 745
- Thanks
- 86
- Thanked in
- 74 Posts
-
27th April, 2018, 02:16 AM #3Senior Member
- Join Date
- Jan 2014
- Location
- Michigan State USA
- Posts
- 297
- Thanks
- 5
- Thanks
- 53
- Thanked in
- 34 Posts
How did you connect with carprog
Originally Posted by borshch
Obdii on table or inside car
Sent from my iPhone using Tapatalk
-
27th April, 2018, 02:17 AM #4DK Veteran
- Join Date
- Jul 2016
- Location
- USA
- Posts
- 1,278
- Thanks
- 745
- Thanks
- 86
- Thanked in
- 74 Posts
2016 nissan murano infineon airbag -security access error for carprog
It was eeprom and outside of car. Eeprom was desoldered tho. Originally Posted by KALNAJJAR01
I always desolder eeproms.
but carprog sometime have to try read / write few times and restart and try again sometime in my sistuations , and I have original carprog
-
27th April, 2018, 02:30 AM #5Senior Member
- Join Date
- Jan 2014
- Location
- Michigan State USA
- Posts
- 297
- Thanks
- 5
- Thanks
- 53
- Thanked in
- 34 Posts
I can not read crash Originally Posted by KALNAJJAR01
Sent from my iPhone using Tapatalk
-
27th April, 2018, 02:54 AM #6Senior Member
- Join Date
- Jan 2014
- Location
- Michigan State USA
- Posts
- 297
- Thanks
- 5
- Thanks
- 53
- Thanked in
- 34 Posts
Brother this is infineon not eeprom Originally Posted by KALNAJJAR01
Sent from my iPhone using Tapatalk
-
2nd August, 2018, 12:26 PM #7Newbie
- Join Date
- Aug 2018
- Posts
- 8
- Thanks
- 2
- Thanks
- 0
- Thanked in
- 0 Posts
What did you end up doing ? I would appreciate it because I currently stuck in the same situation, with the same exact module.
Originally Posted by KALNAJJAR01
Bookmarks