you need canblocker
you need canblocker
levisdj (21st May, 2018)
This has an option to block ezs sync with dash ... not sure if it's safe tho...
I got one w204 with can block problem, I don`t like it, now its avoid any kind of synchronization.
any kind of synchronization.
Can blocer no need its reflash zgw (rewrite this with block sunhro) but its no good tool.
Because I have this ,and 4 cars to do very well and 2 cars kill flash in cgw (50% rewrite stoped thats all).After no comuication in car.So with digmigi3 gameover .Sulution done after in bench with another programmer write full good flash and edit eeprom boot mode out.
After this Im not put this enymore in mersedes.I by for this another tool.So...........50%/50% kill flash.
So............TRY and we will see................................
Last edited by brend; 21st May, 2018 at 10:51 PM.
NB!!! Don't ask in PM old file password , Im not remember.
Sounds tricky... better say no.... thanks for the info!
digiprog the blue one does it no problem. i have done many without problem. have engine running while doing it. you will see km go to 1,6 million km then few seconds later your desired km show up.
Failure is success, if we learn from it......Greetings from down under..... ( Australia )
levisdj (23rd May, 2018)
Nicolas9 (22nd May, 2018)
And I tought that Digimaster beeing original tool will be more trustwortly... Rtronics if you tested 2012 model also... I will give it a go with Digiprog.... thanks for the info!
bad job maxing ezs to 1.6m km, voids warrenty at dealership and will fail plausability test at mercedes. use can blocker and read eeprom before installaing blocker. when you need to lower km, reload dash eeprom data and assyst data will line back up
Stop getting worried about what could go wrong, and start getting excited about would could go right!
hmmmmmmm........eeprom
Digi v4.94, Xtool, R260, R270, Smok, VagProg DataSmart 3+ Smelecom, Autel Maxisys ms908, SpeedFilters
The best way is to set EZS to virgin , do dashboard and after that do adaption and personalization of EZS. Of course if you have advanced tools like genuine AVDI.
Sent from my SM-G925F using Tapatalk
Not possible to reset EZS of W204, W212, W176, W246 and later, all NEC or other chips and can not be programmed.
Bookmarks