..................
Bult.
For you give wrong information.
So......100%correct information its corrupted .
And I think FVDI killer to do this.
For restore help, need know flash signature/index .
..................
Bult.
For you give wrong information.
So......100%correct information its corrupted .
And I think FVDI killer to do this.
For restore help, need know flash signature/index .
Last edited by brend; 22nd May, 2018 at 11:44 AM.
NB!!! Don't ask in PM old file password , Im not remember.
Please send name programmer ???
Clone or original ???
Name car, name BSI, send foto + full info.
Thx.
Oh and by the way if my post has been at all helpfull
please press the little THANKS
Programmer : FVDI
Make : Clone
Car : Peugeot 308 VTI, 1600cc, Auto transmission
BSI : see the picture.
Problem : When read pin code, the whipper and the head lights are on, then, I switch it off. I took out the whipper fuse (in BSM) I switch it on again. After sometime, pc screen prompt out, "Something is going wrong". Then, off the switch again and switch it on, the whole power system fail ( not even room lights ). So, the BSI corrupted.
Please help.
IMG_20180417_075144.jpg
Hi Vasa,
I use FVDI. There is NO communication between BSI and FVDI.
If I change to another BSI, there is communication and show software signature.
Please advice.
Regrads.
if bsi no comunication than only way is programmer read write flash but faster way now is used bsi and adapt all on car good luck
go to web site ioterminal he have connection on table try this connection FVDI never kill BSI only boot mode show in abrites folder maybe is backup files isnt good but have software sig. Now i read you second post ... You kill flashing procedur. You need programmer
Last edited by vasa; 23rd May, 2018 at 09:39 PM.
Hi Vasa,
A lot of information on IOterminal web site. Thanks.
After go thru the information, the device have to use CAN bus to communicate.
Since there is no way to communicate to the BSI, i must need programmer, something like Orange, solder some wires to the micro controller, easyCAN4 ( but don't know the real IC's code ).
I did on Peugeot 307 BSI, to read pin code. It work.( Only on eeprom which is built inside the micro controller ) ( hardware like solder some pins on the pcb, so that can read and write )
So, i need the programmer.
Which programmer i should buy ?
Please advice.
Regards.
I think it is easiest way to buy used bsi and program to car,
I have also problem like you but i alive bsi
I take bsi out off car and conect pins direct on bsi.
I think it we be good to make backup of eeprom 96128
I have somwere bsi pinout you can also find here on site
Hi kzagt,
Yes, I got the wire diagram on BSI.
I can run it on bench with Diagbox and FVDI.
After I run the BSI on the car with FVDI, I corrupt the BSI before I read this web site.
So, one question to ask, if the BSI work on the bench with FVDI ( read pin code, correct mileage, read Flash ) should no problem, right ?
Please advice.
Regards.
Not you cant read PIN mileage correction with FVDI on bench (maybe read flash is posible but not trying). In instaling FVDi PSA dabase missing all flash backup. And you will be in same situation as in car BSI in Boot mode .....Wating for good Flash. You need another tool
Bookmarks