polo 6r cluster dead

**Dejfat** · 23rd May, 2018, 04:20 PM

hi. i was doing a vw polo 6r jc 95320 with fvdi and the cluster just went dead and car can not start. any help please

**Nicolas9** · 23rd May, 2018, 05:51 PM

try reset battery for few minutes?

**Dejfat** · 23rd May, 2018, 05:52 PM

i did for over 30min

**Nicolas9** · 23rd May, 2018, 06:23 PM

did you exit service mode?

**Dejfat** · 23rd May, 2018, 07:04 PM

i did not use service mode

Originally Posted by Nicolas9

did you exit service mode?

**PierreTheron** · 23rd May, 2018, 07:07 PM

dID YOU READ EEPROM AND SAVE IT ???

hERE vIVO 2011 DASH file 2011
10b TO 10C CONVERT DEC TO HEX AND YOU HAVE PIN

**Dejfat** · 23rd May, 2018, 07:09 PM

i did not read before re calibration. i read the eeprom now and it is corrupt. i tried another dump from dk dash came on but no immo

**PierreTheron** · 23rd May, 2018, 07:13 PM

What year model your car m8 ?

What number ecu in the vehicle ??

Get pin from ecu
Take another dash file
Reset file with pin from dashfile and then code pin from ecu to dash file and job done ..

Always make backup off any files where possible ....

**Dejfat** · 23rd May, 2018, 07:17 PM

the car is 2014

**Dejfat** · 23rd May, 2018, 07:21 PM

here dump file

**PierreTheron** · 23rd May, 2018, 07:22 PM

Can please put file from other dash on dk here so we can get pin ???

**Dejfat** · 23rd May, 2018, 07:26 PM

file from dk to compare

**sendreq** · 23rd May, 2018, 08:46 PM

Do you still have communication with dash?
If yes, then:
1. Try to read the IMMO data. Maybe it is not corrupted.
2. Try to redo the procedure.

If no - find someone who can extract the IMMO data from engine ECU and then prepare new (second hand) instrument cluster.

**sendreq** · 23rd May, 2018, 08:49 PM

Originally Posted by PierreTheron

What year model your car m8 ?

Get pin from ecu
Take another dash file
Reset file with pin from dashfile and then code pin from ecu to dash file and job done ..
.

This is not IMMO3 anymore, it will not work like that.

**Gleb068** · 23rd May, 2018, 09:30 PM

do you have anything to put the keys? if Yes, then read motor and the panel, out with the file, do sync, and the keys itself you will guess, with the ABS coding was not flown?