Register
Results 1 to 5 of 5
  1. #1
    DK Veteran

    Join Date
    May 2010
    Posts
    3,958
    Thanks
    382
    Thanked 992 Times in 805 Posts
    Downloads
    4
    Uploads
    0

    Default crafter 2012 key programming

    someone can guide me how to program a key from a crafter 2012?
    van have 2 keys and both you can start the van with but after 1 sec. the engine cut off again. immo problem.
    i have read the ezs and fimd the pin code.
    i have try to relearn the keys with vcds and van start 1 time but when switch the ignition off you get same problem again.
    can i make a key with Tango china?
    i have only vcds and Tango china.

  2. #2
    DK Veteran
    rob h's Avatar
    Join Date
    May 2011
    Posts
    1,974
    Thanks
    595
    Thanked 1,041 Times in 748 Posts
    Downloads
    0
    Uploads
    0

    Default

    Your Keys are fine.
    The problem is most likely elswere

  3. The Following User Says Thank You to rob h For This Useful Post:

    vageric (16th June, 2018)

  4. #3
    DK Veteran

    Join Date
    Mar 2013
    Location
    Europe
    Posts
    1,179
    Thanks
    168
    Thanked 415 Times in 213 Posts
    Downloads
    38
    Uploads
    0

    Default

    DTC's in ECU?

  5. The Following User Says Thank You to bersch8688 For This Useful Post:

    vageric (16th June, 2018)

  6. #4
    DK Veteran

    Join Date
    May 2010
    Posts
    3,958
    Thanks
    382
    Thanked 992 Times in 805 Posts
    Downloads
    4
    Uploads
    0

    Default

    dtc's were cranckshaft sensor and immo if i remember correct.

  7. #5
    V.I.P. Member
    Fallen's Avatar
    Join Date
    Dec 2009
    Posts
    2,121
    Thanks
    1,344
    Thanked 1,214 Times in 527 Posts
    Downloads
    25
    Uploads
    0

    Default

    I saw a similar problem a while back.
    If you disconnected the battery it would start only once and then stop when it was turned off.
    Repeat to start again.

    Never heard what the problem with it was.

  8. The Following User Says Thank You to Fallen For This Useful Post:

    vageric (16th June, 2018)

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •