Register
Results 1 to 5 of 5
  1. #1
    DK Veteran

    Join Date
    May 2010
    Posts
    3,851
    Thanks
    363
    Thanked 930 Times in 762 Posts
    Downloads
    4
    Uploads
    0

    Default crafter 2012 key programming

    someone can guide me how to program a key from a crafter 2012?
    van have 2 keys and both you can start the van with but after 1 sec. the engine cut off again. immo problem.
    i have read the ezs and fimd the pin code.
    i have try to relearn the keys with vcds and van start 1 time but when switch the ignition off you get same problem again.
    can i make a key with Tango china?
    i have only vcds and Tango china.

  2. #2
    DK Veteran
    rob h's Avatar
    Join Date
    May 2011
    Posts
    1,674
    Thanks
    481
    Thanked 885 Times in 633 Posts
    Downloads
    0
    Uploads
    0

    Default

    Your Keys are fine.
    The problem is most likely elswere

  3. The Following User Says Thank You to rob h For This Useful Post:

    vageric (16th June, 2018)

  4. #3
    DK Veteran

    Join Date
    Mar 2013
    Location
    Europe
    Posts
    1,096
    Thanks
    150
    Thanked 336 Times in 192 Posts
    Downloads
    38
    Uploads
    0

    Default

    DTC's in ECU?

  5. The Following User Says Thank You to bersch8688 For This Useful Post:

    vageric (16th June, 2018)

  6. #4
    DK Veteran

    Join Date
    May 2010
    Posts
    3,851
    Thanks
    363
    Thanked 930 Times in 762 Posts
    Downloads
    4
    Uploads
    0

    Default

    dtc's were cranckshaft sensor and immo if i remember correct.

  7. #5
    V.I.P. Member
    Fallen's Avatar
    Join Date
    Dec 2009
    Posts
    2,098
    Thanks
    1,322
    Thanked 1,155 Times in 514 Posts
    Downloads
    25
    Uploads
    0

    Default

    I saw a similar problem a while back.
    If you disconnected the battery it would start only once and then stop when it was turned off.
    Repeat to start again.

    Never heard what the problem with it was.

  8. The Following User Says Thank You to Fallen For This Useful Post:

    vageric (16th June, 2018)

 

 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •