ahhhh i see
your problem is you are bad at taking pictures!
hhahahahahaha
seriously tho the close ups of all black wires is so not helpful
I am trying to get a EEPROM dump from a 0L15Y CAS3+ from a 2008 BMW 5er. This is from a Junkyard so if I mess it up it will not matter. I am just doing this as a DIY activity. When I hit read it will just sit at "Send Command wait". I am assuming something is not hooked up right but I am not sure what is. I have version 1.20 of the software running on a Windows XP laptop. This is a R270 from Aliexpress.
IMG_20180714_170703.jpgIMG_20180714_170936.jpgIMG_20180714_170940.jpgIMG_20180714_170944.jpgIMG_20180714_141629.jpg
http://blog.eobdtool.co.uk/wp-conten...S3_0L15Y-3.jpg
Anyone have any ideas?
ahhhh i see
your problem is you are bad at taking pictures!
hhahahahahaha
seriously tho the close ups of all black wires is so not helpful
the points look correct
i cant tell if the correct wire is going to the correct place because they are all black tho
http://www.digital-kaos.co.uk/forums...as3-mask-0L15Y
IMG_20180714_201055.jpgIMG_20180714_201050.jpgCAS3+_0L15Y.JPGR270_cable.JPG
All of the solder points are bang on from the guides. I went off wire numbers 1,5,7,8,19,24,26 starting with the wires with the 1 label on it. All of the wires I can tug on them without them ripping out.
Last edited by Ulsmak; 15th July, 2018 at 01:18 AM.
Do you know the cas version?
I was been unable to read a CAS3+ IstaP with R270.
Bookmarks