http://dpfegr.ru/mercedes-edc16cp31/
like that ...dont open it just cut it....
open will damage it
Hello!
How to open Mercedes A160 2005, 2.0 CDI EDC16C32 ECU for BDM access please?
Possible to remove cover without damage?
After EGR Off ECU is dead.
Via OBD no access to ECU!
Last edited by Aivis3; 18th July, 2018 at 08:28 AM.
If helped - "Thanks" and "Reputation" please
http://dpfegr.ru/mercedes-edc16cp31/
like that ...dont open it just cut it....
open will damage it
Is bosch edc16, standard pads will be in pcb.
they ll be in the same blace bottom left side
check picture and take size from left bottom corner
OK, I will try to cut it.
maybe somebody have a BDM dump for it?
SW: 392623
If helped - "Thanks" and "Reputation" please
I think this one is flip ecu?
AUTOTUNER, FLEX ,X17, TRASDATA / NEW GENUIS AND ALIENTECH MASTER OWNER.
FULL SWIFTEC AND EVC RESELLER
FILE SERVICE FROM 8AM - 9PM 7/7
BAPRO 4WD DYNO
Problem again...
I get access to BDM, Connect to M58BW016DB OK
Start reading OK, but 87% get error every time....
need a help please..
If helped - "Thanks" and "Reputation" please
Your Fgtech rework?
Test on Windows XP
or Use Ktag ;-)
Last edited by Aivis3; 19th July, 2018 at 07:00 AM.
If helped - "Thanks" and "Reputation" please
Today was readed by Xprog 7 times! Allways Verification NOT OK!
Allways problem in address: 001C00000 - 001CFFFFF
I erase flash and get Verification OK! I create BDM dump from Xprg readed and OBD readed dump.
Then write to ECU, Verification OK!
But car not start... (Starter not turn, Fan running) What is wrong?
After BDM read correct software is : 377534
I was found couple 377534 dumps, but not same with my dump.
Last edited by Aivis3; 19th July, 2018 at 09:06 PM.
If helped - "Thanks" and "Reputation" please
klonone (11th April, 2019)
i'm not sure about a-class, but for example sprinter edc16c31 has eeprom emulated in flash ( so immo area is in flash)
bFlash/Kess/Ktag/CMD Master
DPF/EGR/DTC/AdBlue/ChipTuning. ------>PM
If the fan runs - the ECU is in not operational state.
Still in boot mode, dead, etc...
Have you comm. with it? What dtcs are shown?
NO PASSWORDS FOR ANYONE, EXCEPT THE RECIPIENT OF THE FILE !!!
If your PM box is full, clean it right now...
Otherwise, your requested file will be deleted... for ever!
End of story!
Dump repaired and the car started up!
If helped - "Thanks" and "Reputation" please
Bookmarks