ECU chip damaged, solution?

[Richi777]

I think better no waste your time and buy a other ecu
And read new ecu with bdm frame

[Sefior]

*UPDATE*

I have bought another ECU and have it now in hand..
What is the next steps to make it work with car?

VCDS adapt it? IMMO OFF?

[morgano]

VCDS Can't adapt, for immo off, just read eeprom and upload here.

[Sefior]

VCDS Can't adapt, for immo off, just read eeprom and upload here.

For some reason I can not read the ECU with KTAG bench mode

Is it possible to read it with LED frame + pins or I must solder wires on the ECU?

*UPDATE*

I get MICRO PROTECTION REMOVAL FAILED error when trying to read it.

[bouch]

if you have time . send me the ecu par package. I can try to repair it.
I am in France

[Sefior]

if you have time . send me the ecu par package. I can try to repair it.
I am in France

I could send it yes, but its still not readable..
I think KTAG & Kess has error reading this ECU, I read that online..

PM me with info bro I might send it to you.

[quikcar]

post picture of the label ecu
i will give you full buckup
write it in new one
do immo off
car start

[morgano]

For some reason I can not read the ECU with KTAG bench mode

Is it possible to read it with LED frame + pins or I must solder wires on the ECU?

*UPDATE*

I get MICRO PROTECTION REMOVAL FAILED error when trying to read it.

You may have selected wrong protocol.

[Sefior]

post picture of the label ecu
i will give you full buckup
write it in new one
do immo off
car start

Here it is, thank you man.

ECU.jpg

[Sefior]

You may have selected wrong protocol.

No sir. I selected P199, like several people said over the internet, there is a error reading this ECU and selecting P199 should fix that error, but nope.

[morgano]

Depending the tprot level you should choose correct protocol, if 199 not working you may select the one for higher tprot.

[quikcar]

Here it is, thank you man.

ECU.jpg

VW Passat 2.0D, 0281017946, 03L907309AE, 1039s48626 , EDC17C46

[Sefior]

I get a error message when trying to read the ECU.

"Communication error with the ECU: control all connections; if the problem persists, send the LOG file to the assistance"

Anyone knows why?