Renault Clio 2 T5 key clone problem...

[WinWoj]

Hello Folks,

I have problem with cloning T5 transponder key in my Clio2. I put good one key to zedbull mini and EFFi software.
Good one key shows me 33 Philips with DATA, PCF7930, TYPE 33 REN WR, PINCODE.

I put another useed, and when try to write these data read above, zedbull mini shows "NO TRANSPONDER" and EFFi
shows also the same... What is the problem? I have 3 another used keys from another cars, all can't be written.

This is Sirius32N ECU, UHC with 93C46, key transponder is in chip on small PCB. Please help me to understand how to write data
to thise 3 used key. All if them have PIN in zedbull mini read description, but no possibility to use this pin in EFFi software.

Best Regards.
IMG_20180815_125157.jpg IMG_20180815_125351.jpg

[rafal]

maybe will help
http://www.digital-kaos.co.uk/forums...te-programming

[WinWoj]

maybe will help
http://www.digital-kaos.co.uk/forums...te-programming

I saw it, thanks, but not all are clear for me. In effi i can't find any step in read,i'll try to read dump from UCH and try to generate key.

[doctore]

only can generate new t5 not board used

[WinWoj]

only can generate new t5 not board used

So there are no possibility to clear T5 data or modyfing 93C46 from UCH to set used key from another car?

I found 2 pairs of key from 2 cars. So I have 2 UHC's, both with 2 keys.
One UHC have PIN found in 2 keys and second UHC has another PIN found in his 2 keys...

As I understand, if I would like to add 3rd key or clone one from 2 existed, only new clear pcb transponder needed.

EDIT: may I use new empty chip (PCF7946) and solder it to pcb and then program key using 93C46 from UCH??

[doctore]

only can used set with remote

or can save your remote for spare parts

[lion0304]

This Clio 2 Ph1 have only one key data store in UBIC.

If you want use another set UBIC +Key, just virgin ECU then plug n play.

If you want to clone another key, use T5 chip clone with Zedbull.

[WinWoj]

This Clio 2 Ph1 have only one key data store in UBIC.

If you want use another set UBIC +Key, just virgin ECU then plug n play.

If you want to clone another key, use T5 chip clone with Zedbull.

I know that I can use T5 chip, the question is what is orginal transponder in this key - coil or 20-pin smd chip??

Edit: OK, I found that UM9280M is the chip contained transponder. So where can be new one pcb available?
Brand new key should be possible to add using Clip.
1. How can i get new transponder with UM9280M chip?
2. Is it possible to change PIN in this transponder type?