its normal for vehicle to not run after airbags deployed, in engine ecu you will need to go into starting conditions and reset impact detected codes, if no comunication and no ignition lights check fuse box on n/s inner wing
Hi,
Has anyone else had this problem, i have had two this week,
not very heavy damage but air bags deployed,
i reset the airbags and all lights are off for airbags but it will not start, no communication is possible with the ecu with clip or modis all fuses are ok its as if the ecu has locked its self?
no immo light flashing but the mil light is on,
can anyone offer me any advise to get these cars going again please
BR
Dave
its normal for vehicle to not run after airbags deployed, in engine ecu you will need to go into starting conditions and reset impact detected codes, if no comunication and no ignition lights check fuse box on n/s inner wing
Hi
Thank you for your reply, I thought it must be something like that i have checked all the fuses and all are good and cant find a pin out for this ecu yet
Have u checked the fuel pump impact switch???
Cheers
there is no fuel impact switch on these, its done through the ecu
Hi
Is this the one with Nissan System in there.........
Check the fuse box behind N/S Head Light
Which side was damaged............
Thanks Ash
Oh yes if my post was helpful than Please don't forget to press the Magic word Thanks
it was O/S damage Ash,
checked that fuse box and the one inside below the steering wheel
All fuses are good unless i am missing some hidden fuses?
Last edited by Ashraf6119; 6th May, 2012 at 01:13 PM.
Thanks Ash
Oh yes if my post was helpful than Please don't forget to press the Magic word Thanks
Thank you i will look there ASAP
hi a guy i know repaired 1 of these 2010 or newer clio.
car wouldnt start etc so he gave me control module to reset. out of curiousity he tried again then the car started with no airbag control module, so try that, and when reset module needs reconfigured. !
does the immo light go out?
Was Banned For Being Certifiably Insane and Stupid
yes immo light works normally,
will try and get back to it next week and check that hidden fuse box
Disconnect the battery remove airbag fuse or connector ,clear fault codes in ECM (EVEN if there aren't any)
Say a prayer and/or have a beer,this should do it!
A failure will not appear till a unit has passed final inspection
i have the same problem on a 56 plate ford c max
from memory fuel pump inertia is built into airbag module on clio III's and many more newer cars, erase crash data should fix, even if airbags have not been deployed they can still trigger a code and shutdown fuel pump
Check out The Number 1 Resource for all Automotive Software with a lot of patience you like me will find what you need...
Bookmarks