PCR 2.1 Eeprom help

[irco]

Hi

I need some help to know if this eeprom is unlocked or not and his pin/cs

Thanks


Ps: this ecu is supposed to be virgin

[avital]

For see immo data in PCR2.1 , must have full read , but not for tunning it must really FULL from MCU.

[irco]

Thanks

I will read it and post dump in few hour


EDIT: Wich tool can be used to make full read?

[RATON3101]

HELLO, YOU CAN USE GALLETTO V54 AT THE BANK. I TURN YOU PIN UP.

[RATON3101]

HELLO, YOU CAN USE GALLETTO V54 AT THE BANK. I TURN YOU PIN UP

[irco]

I can't read it on banch.
identification ok but when read it give error like in the photo

IMG_6785.jpg
IMG_6786.jpg

[Pyromaniak]

How you power your setup? Maybe its your power suply weak....

[irco]

I have a good power supply. Perhaps a mistake of mine or version of Galetto witch is 2012 version or Kess v2 FW 4.036

With same setup already done unlock on boot mode with fgtech galetto of PCR2.1 on 2 others than read and write on car with OBD

with kess v2 I get error when reading on pictures attached. The car come like this with supposdly dash and ecu virginised by some one because the car loosed original dash.

PS: I tried programe key on new dash succefully than tried to make adaptation of ecu with vvdi2 and fvdi but stuck on searching power class

[irco]

I wasn't able to read full flash so is bad thing for this car

Can some one explain the ways to do this kind of car in this situation

Original PCR2.1 of the car with spare dash was sent by the owner of the car to some one to make them virgin.

So I have 2 question: - Is it possible to do make them virgin especially SIMOS PCR2.1 ?
- how to do in this case?

Thanks to all