Most likely your tool doesn't support this specific version.
Hi guys
i was trying to extract the skey and sec block from this speedo on the bench
id was ok
was using smok
i did the short pin 5 of eep trick
sec access ok
but when it got to read skey i get init fail !!
Reading S-Key OBD v 1 ...
Licence Accepted
Init Ok
SW: 0710
Conditions Ok
Security Access Ok
Soft loaded ok, Please Wait...
Soft Started ok, Please Wait...
Soft RSA ok, Please Wait...
Sec Access II OK
Please Wait - Reading...
Reading S-Key...
Licence Accepted
Init Error
Read S-KEY Error - You must Prepare EEprom
driving me crazy
so i tried prep eeprom but still same
will not spit out the skey
i know once i have this i have sec sccess and it should spit out the sec block for me so i can code them into my vehicle.
anyone any ideas ??
this pic is the mcu
dont look like NEC to me tho
the eepro is a 24lc64
thanks
Tools owned.
AVDI commander.
Dashfixer orig.
Dashfixer clone.
Fiat km tool.
Opel km tool.
Ford KM tool.
Op--com colne.
Lexia & PP clone.
Smok PSA, volvo & ford
If someone helps you DONT FORGET TO SAY THANKS its only polite....
Most likely your tool doesn't support this specific version.
ask Smok tech support.
good tool can do that easy
smok support is like a joke, smok can only count money
Im smok reseller
mr smok wasnt available this day i was try
i try help all my customers
Tools owned.
AVDI commander.
Dashfixer orig.
Dashfixer clone.
Fiat km tool.
Opel km tool.
Ford KM tool.
Op--com colne.
Lexia & PP clone.
Smok PSA, volvo & ford
If someone helps you DONT FORGET TO SAY THANKS its only polite....
Bookmarks